Check At AWC-Ecu Terminal
WARNING: This page is about a different car, the 2014 Mitsubishi Outlander. However, it is still accessible from the selected car via links, so may be relevant.
| Terminal No. | Terminal code | Inspection Items | Inspection requirement | Normal Condition | |
|---|---|---|---|---|---|
| 1 | FSL+ | Electronic control coupling solenoid (front) | Using scan tool (M.U.T.-III), perform "Test Item No. 4: Control OFF" of "SPECIAL FUNCTION" | 0 A | |
| Using scan tool (M.U.T.-III), perform "Test Item No. 5: Front coupling operation check" of "SPECIAL FUNCTION" | 0 to 5 A | ||||
| 2 | SOL+ | Electronic control coupling solenoid (center) | Using scan tool (M.U.T.-III), perform "Test Item No. 4: Control OFF" of "SPECIAL FUNCTION" | 0 A | |
| Using scan tool (M.U.T.-III), perform "Test Item No. 6: center coupling operation check" of "SPECIAL FUNCTION" | 0 to 5 A | ||||
| 3 | SOL- | Electronic control coupling solenoid (center) ground | Always | 0 V | |
| 6 | SW-1 | Drive mode selector | Ignition switch: ON | Drive mode selector: ON | 0 V |
| Drive mode selector: OFF | Battery positive voltage | ||||
| 12 | 4WDF | Power supply | Always | Battery positive voltage | |
| 13 | GND1 | Ground | Always | 0 V | |
| 14 | FSL- | Electronic control coupling solenoid (front) ground | Always | 0 V | |
| 16 | IG16 | Ignition switch | Ignition switch: ON | Battery positive voltage | |
| Ignition switch: OFF | 0 V | ||||
| 23 | CANH | CAN-H | - | - | |
| 24 | CANL | CAN-L | - | - | |