Oscilloscope Inspection Procedures

WARNING: This page is about a different car, the 2014 Mitsubishi Outlander. However, it is still accessible from the selected car via links, so may be relevant.

With the connector remain connected, connect the oscilloscope probe to each terminal of TCM.

Terminal No.	Check item	Check conditions	Normal conditions	Wave patterns
36 - 26	Secondary pulley rotation sensor	Selector lever position: D Drive at a constant speed of approx. 20 km/h (12 mph)	Between 0 and 4.5 V, the pulse cycle is constant.
37 - 26	Primary pulley rotation sensor		Between 0 and 4.5 V, the pulse cycle is constant.