Customization Function
WARNING: This page is about a different car, the 2014 Mitsubishi Outlander. However, it is still accessible from the selected car via links, so may be relevant.
Using the ETACS system of scan tool (M.U.T.-III), the following functions can be programmed. The programmed information is held even when the battery is disconnected.
| Adjustment item (scan tool display) | Adjustment item | Adjusting content (scan tool display) | Adjusting content | ||
|---|---|---|---|---|---|
| Turn power source | Adjustment of turn-signal light operation condition | ACC or IG1 | Operable with ACC or ON position | ||
| IG1 | Operable with ON position (initial condition) | ||||
| Comfort flasher | With/without comfort flasher function | Disable | No function | ||
| Enable | With function (initial condition) | ||||
| Hazard answer back | Adjustment of the number of keyless hazard warning light answer back flashes | Lock: 1, Unlock: 2 | LOCK: Flashes once, UNLOCK: Flashes twice (initial condition) | ||
| Lock: 1, Unlock: 0 | LOCK: Flashes once, UNLOCK: No flash | ||||
| Lock: 0, Unlock: 2 | LOCK: No flash, UNLOCK: Flash twice | ||||
| Lock: 2, Unlock: 1 | LOCK: Flash twice, UNLOCK: Flash once | ||||
| Lock: 2, Unlock: 0 | LOCK: Flash twice, UNLOCK: No flash | ||||
| Lock: 0, Unlock: 1 | LOCK: No flash, UNLOCK: Flash once | ||||
| Lock: 0, Unlock: 0 | No function | ||||
| Front wiper operation | Adjustment of the intermittent windshield wiper operation < vehicles without lighting control sensor or vehicles without LDW > | Normal INT | Intermittent wiper interval is fixed to 4 seconds. | ||
| Variable INT | Intermittent wiper interval is calculated only by the wiper volume control. | ||||
| Speed Sensitive | Intermittent wiper interval is calculated according to the intermittent wiper volume control and vehicle speed (initial condition). | ||||
| Adjustment of the intermittent windshield wiper operation < vehicles with lighting control sensor or vehicles with LDW > | Normal INT | Intermittent wiper interval is fixed to 4 seconds. | |||
| Variable INT | Intermittent wiper interval is calculated only by the wiper volume control. | ||||
| Speed Sensitive | Intermittent wiper interval is calculated according to the intermittent wiper volume control and vehicle speed. | ||||
| Rain Sensitive | Intermittent wiper interval is calculated according to the intermittent wiper volume control and lighting control sensor (initial condition). | ||||
| Front/rear wiper washer | Disabling or enabling washer-linked wiper function | Only Washer | No function | ||
| Washer & Wiper | With function: Without delayed finishing wipe function < Initial condition > | ||||
| With after wipe | With function: With delayed finishing wipe function | ||||
| Intermittent time of rear wiper | Adjustment of rear wiper interval | 0 sec. | No wiper interval | ||
| 4 sec. | 4 seconds | ||||
| 8 sec. | 8 seconds (initial condition) | ||||
| 16 sec. | 16 seconds | ||||
| Rear wiper Low speed mode | Disabling or enabling rear wiper continuous operation | Disable | No function | ||
| Enable | With function (initial condition) | ||||
| Sensitivity for auto light | Lighting control sensor sensitivity (illumination intensity) < vehicles with lighting control sensor or vehicles with LDW > | Level 1 bright | High-high ambient brightness | ||
| Level 2 bright | High ambient brightness | ||||
| Level 3 | Standard ambient brightness (initial condition) | ||||
| Level 4 dark | Low ambient brightness | ||||
| Level 5 dark | Low-low ambient brightness | ||||
| Dome light delay timer with door | Adjustment of interior light delay shutdown time | 0 sec. | 0 second (no delay shutdown time) | ||
| 7.5 sec. | 7.5 seconds | ||||
| 15 sec. | 15 seconds | ||||
| 30 sec. | 30 seconds (initial condition) | ||||
| 60 sec. | 60 seconds | ||||
| 120 sec. | 120 seconds | ||||
| 180 sec. | 180 seconds | ||||
| Headlight auto cut customize | Adjustment of headlight automatic shutdown function | Disable | No function | ||
| Enable (C-spec.) | With function (initial condition) | ||||
| Interior light auto cut timer | Adjustment of interior light automatic shutdown function operation time | Disable | No function | ||
| 3 min | 3 minutes | ||||
| 30 min | 30 minutes (initial condition) | ||||
| 60 min | 60 minutes | ||||
| Comfort flasher switch time | Switch operation time to activate the comfort flasher function | Normal | 0.4 second (initial condition) | ||
| Long | 0.8 second | ||||
| Intelligent washer | With/without intelligent washer function | Disable | No function | ||
| Enable | With function (Initial condition) | ||||
| Auto door unlock | Adjustment of the auto door unlock function | Disable | No function (initial condition) | ||
| Always (P pos) | With function: Operates when the shift lever or the selector lever is moved to the P position. | ||||
| Always (Lock pos) | With function: Operates when the ignition switch is moved to the LOCK (OFF) position. | ||||
| Door unlock mode | Adjustment of power door locks with selective unlocking | All doors unlock | Without function: The first operation of keyless entry system or unlock operation by KOS unlocks all doors. | ||
| Dr door unlock | With function: The first operation of keyless entry system or unlock operation by KOS unlocks the driver's door only, and the second unlock operation within 2 seconds after that unlocks all doors. (initial condition) | ||||
| Horn chirp by keyless | Horn chirp by keyless entry system < vehicles with LDW > | Not sound horn | No horn answerback function | ||
| Lock any time | The horn sounds when the lock button of keyless entry transmitter is pressed once. | ||||
| W lock any time | The horn sounds when the lock button of keyless entry transmitter is pressed twice. (initial condition) | ||||
| Horn chirp by keyless entry system < vehicles with lighting control sensor > | Not sound horn | No horn answerback function | |||
| Lock any time | The horn sounds when the lock button of keyless entry transmitter is pressed once. | ||||
| Lock/auto ON | During daytime, while the lighting switch is in the AUTO position, the horn sounds once when the lock is pressed once. | ||||
| W lock any time | The horn sounds when the lock button of keyless entry transmitter is pressed twice. (initial condition) | ||||
| Buzzer answer back | Adjusts the tone alarm answer back function. | Not Sound Buzzer | No function | ||
| At keyless | Sounds when the keyless entry system is activated. | ||||
| At F.A.S.T.(1) | Sounds when KOS is activated (initial condition). | ||||
| At Both | Sounds when the keyless entry system or KOS is activated. | ||||
| Timer lock timer | Timer lock period adjustment | 30 sec | 30 seconds (initial condition) | ||
| 60 sec | 60 seconds | ||||
| 120 sec | 120 seconds | ||||
| 180 sec | 180 seconds | ||||
| Panic alarm switch | With/without panic alarm function | Disable | No function | ||
| Enable | With function (initial condition) | ||||
| Duration of horn chirp | Horn sounding time during horn answer back | Short | 0.01 second (initial condition) | ||
| Long | 0.02 second | ||||
| Rear wiper (linked reverse gear) | Adjustment of automatic rear window wiper operation with reverse gear engaged | Enable (R wip.ON) | Operates only when the rear wiper switch is ON. | ||
| Enable (R/F wip.) | Operates only when the front or rear wiper switch is ON (initial condition). | ||||
| F.A.S.T.(1) key detect out fm window | With/without KOS key exterior detection function < Vehicles with KOS > | Enable | No function | ||
| Disable | With function (initial condition) | ||||
| F.A.S.T.(1) feature | KOS function adjustment < Vehicles with KOS > | Both enable | All KOS functions are enabled (initial condition). | ||
| Door Entry enable | Only door entry function is enabled. | ||||
| ENG start enable | Only engine starting function is enabled. | ||||
| Both disable | All KOS functions are disabled. | ||||
| F.A.S.T.(1) unlock disable time | Adjusts the door unlock inhibition period after door lock is activated. < Vehicles with KOS > | 0 sec. | 0 second | ||
| 3 sec. | 3 seconds (Initial condition) | ||||
| 5 sec. | 5 seconds | ||||
| Remote ENG starter answer back | Remote engine starter answer back function adjustment | Disable | No function (Initial condition) | ||
| Enable | With function | ||||
| ACC power auto cut | Time to ACC power cut-off when the ignition switch is in the ACC position | Disable | No function | ||
| 30 min | 30 minutes (initial condition) | ||||
| 60 min | 60 minutes | ||||
| Sensitivity for theft sensor | Sensitivity level setting of theft-alarm sensor < Vehicles with theft-alarm (vehicles with theft-alarm sensor) > | Level 1 | 100% sensitivity of theft-alarm sensor (initial condition) | ||
| Level 2 | 90% sensitivity of theft-alarm sensor | ||||
| Level 3 | 80% sensitivity of theft-alarm sensor | ||||
| Level 4 | 70% sensitivity of theft-alarm sensor | ||||
| Coming home light | Disabling or enabling coming home light function | Disable | No function | ||
| 15 sec. | Headlight illuminates for 15 seconds. | ||||
| 30 sec. | Headlight illuminates for 30 seconds. (initial condition) | ||||
| 60 sec. | Headlight illuminates for 60 seconds. | ||||
| 180 sec. | Headlight illuminates for 180 seconds. | ||||
| Welcome light | Disabling or enabling welcome light function | Disable | No function | ||
| Small light | Taillight illuminates. (initial condition) | ||||
| Head light | Headlight illuminates. | ||||
| Outer buzzer volume | KOS outer tone alarm volume adjustment < Vehicles with KOS > | Volume 1 | Quieter than the standard | ||
| Volume 2 | Standard volume (Initial condition) | ||||
| Volume 3 | Louder than the standard | ||||
| A/C Recirculation Control | With/without inside/outside air automatic control function | Disable | No function | ||
| Enable | With function (Initial condition) | ||||
| A/C Switch Control | With/without A/C automatic control function | Disable | No function | ||
| Enable | With function (Initial condition) | ||||
| Eco Mode | Function to activate ECO mode air-conditioning | Eco | Activates the ECO mode. | ||
| Comfort | Deactivates the ECO mode. | ||||
| A/C Sensible temp. customize | Adjusting mean value for temperature setting | -2 | Decreases the control temperature two degrees than the temperature displayed on the LCD. | ||
| -1 | Decreases the control temperature one degree than the temperature displayed on the LCD. | ||||
| 0 | No change (Initial condition) | ||||
| 1 | Increases the control temperature one degree than the temperature displayed on the LCD. | ||||
| 2 | Increases the control temperature two degrees than the temperature displayed on the LCD. | ||||
| FOOT/DEF Air outlet ratio | Changes air distribution rate for DEF/FOOT vents during manual operation. | Normal | D/F2 (Initial condition) | ||
| FOOT > DEF | D/F1 (more to FOOT vent): More air flows through FOOT vents. | ||||
| FOOT < DEF | D/F3 (more to DEF vent): More air flows through DEF vents. | ||||
| FACE/FOOT Air outlet ratio | Changes air distribution rate for FACE/FOOT vents during manual operation. | Normal | B/L2 (Initial condition) | ||
| FACE > FOOT | B/L1 (more to FACE vent): More air flows through FACE vents. | ||||
| FACE < FOOT | B/L3 (more to FOOT vent): More air flows through FOOT vents. | ||||
| Auto Rear Defogger (Engine Start) | Activates the rear window defogger when the ambient temperature is low. (The rear window defogger has never been activated since the ignition switch was turned on last time) | Disable | No function (Initial condition) | ||
| Enable | With function | ||||
| Gate auto open by Handle SW | Opening operation by using the gate handle switch | Disable | No function | ||
| Enable | With function (Initial condition) | ||||
|
|||||