Inspection Procedure 11: The column switch signal is not received: Diagnosis

WARNING: This page is about a different car, the 2014 Mitsubishi Outlander. However, it is still accessible from the selected car via links, so may be relevant.

STEP 1. Using scan tool (M.U.T.-III), read the ETACS diagnostic trouble code
CAUTION: To prevent damage to scan tool (M.U.T.-III), always turn the ignition switch to the "LOCK" (OFF) position before connecting or disconnecting scan tool (M.U.T.-III).
1. Connect scan tool (M.U.T.-III). Refer to "HOW TO CONNECT THE SCAN TOOL (M.U.T.-III) ."
2. Check if DTC is stored in the ETACS-ECU.
Q: Is the DTC stored?
1. YES: Refer to DTC CHART .
2. NO: Go to Step 2.
STEP 2. Column switch check
- Check the continuity for wiper switch. Refer to INSTALLATION SERVICE POINT .
- Check the continuity for column switch (switch body part). Refer to COLUMN SWITCH BODY CONTINUITY CHECK .
Q: Is the check result normal?
1. YES: The trouble can be an intermittent malfunction (Refer to HOW TO COPE WITH INTERMITTENT MALFUNCTION ).
2. NO: Replace the column switch.