Inspection Procedure 12: KOS timer lock function does not work: Diagnosis

WARNING: This page is about a different car, the 2014 Mitsubishi Outlander. However, it is still accessible from the selected car via links, so may be relevant.

STEP 1. Check the keyless entry function operation
Check that the keyless entry function operation normally.

Q: Is the check result normal?
1. YES: Go to Step 2.
2. NO: Refer to INSPECTION PROCEDURE 11: "KEYLESS ENTRY FUNCTION DOES NOT WORK ."
STEP 2. Check the door entry function operation
Check that the door entry function operation normally.

Q: Is the check result normal?
1. YES: Go to Step 3.
2. NO: Refer to TROUBLE SYMPTOM CHART .
STEP 3. Using scan tool (M.U.T.-III), read the diagnostic trouble code.
Check if any DTC is stored in the KOS-ECU.

CAUTION: To prevent damage to scan tool (M.U.T.-III), always turn the power supply mode of the engine switch to the OFF position before connecting or disconnecting scan tool (M.U.T.-III).
1. Connect scan tool (M.U.T.-III). Refer to "HOW TO CONNECT SCAN TOOL (M.U.T.-III) ."
2. Turn the power supply mode of the engine switch to ON.
3. Check if DTC is stored.
4. Turn the power supply mode of the engine switch to OFF.
Q: Is the DTC stored?
1. YES: Refer to DIAGNOSTIC TROUBLE CODE CHART .
2. NO: Go to Step 4.
STEP 4. Check of the troubles
Check that the KOS timer lock function operates.

Q: Is the check result normal?
1. YES: Intermittent malfunction is suspected (Refer to HOW TO COPE WITH INTERMITTENT MALFUNCTION ).
2. NO: Perform troubleshooting for each door switch (Refer to TROUBLE SYMPTOM CHART ).