Inspection Procedure 10: The open switch of the liftgate lock release handle does not perform the unlocking operation: Diagnosis

WARNING: This page is about a different car, the 2014 Mitsubishi Outlander. However, it is still accessible from the selected car via links, so may be relevant.

STEP 1. Using scan tool (M.U.T.-III), read the diagnostic trouble code.
Check if any DTC is stored in the KOS-ECU.

CAUTION: To prevent damage to scan tool (M.U.T.-III), always turn the power supply mode of the engine switch to the OFF position before connecting or disconnecting scan tool (M.U.T.-III).
1. Connect scan tool (M.U.T.-III). Refer to "HOW TO CONNECT SCAN TOOL (M.U.T.-III) ."
2. Turn the power supply mode of the engine switch to ON.
3. Check if DTC is stored.
4. Turn the power supply mode of the engine switch to OFF.
Q: Is the DTC stored?
1. YES: Refer to DIAGNOSTIC TROUBLE CODE CHART .
2. NO: Go to Step 2.
STEP 2. Liftgate lock release handle (open switch) check
Check that the liftgate lock release handle (open switch) is normal (Refer to INSPECTION < Vehicles without power liftgate > or INSPECTION < Vehicles with power liftgate >).

Q: Is the check result normal?
1. YES: Go to Step 3.
2. NO: Replace the liftgate lock release handle.
STEP 3. Check of short to power supply, short to ground, and open circuit in GTOP line between the KOS-ECU connector and the liftgate lock release handle connector.
NOTE: Before the wiring harness check, check the intermediate connector, and repair if necessary.

Q: Is the check result normal?
1. YES: Go to Step 4.
2. NO: Repair the wiring harness.
STEP 4. KOS communication test
Using scan tool (M.U.T.-III), perform the antenna communication test to check that the outside transmission antenna assembly (liftgate) communicates normally (Refer to ON-VEHICLE SERVICE < KOS-ECU > ).

Q: Is the check result normal?
1. YES: Go to Step 5.
2. NO: Perform troubleshooting for the diagnostic trouble code B240C (Refer to DIAGNOSTIC TROUBLE CODE CHART ).
STEP 5. Check of the troubles
Operate the liftgate lock release handle (open switch) to check that the liftgate can be opened.

Q: Is the check result normal?
1. YES: Intermittent malfunction is suspected (Refer to HOW TO DEAL WITH INTERMITTENT MALFUNCTION ).
2. NO: Replace KOS-ECU and register the ID codes (Refer to ON-VEHICLE SERVICE < KOS-ECU > ).