DTC B240E: RR antenna (indoor) open: Diagnosis

WARNING: This page is about a different car, the 2014 Mitsubishi Outlander. However, it is still accessible from the selected car via links, so may be relevant.

STEP 1. Check of short to power supply, short to ground, and open circuit in INRP, INRG line between the inside transmission antenna assembly (rear) connector and the KOS-ECU connector.
Q: Is the check result normal?
1. YES: Go to Step 2
2. NO: Repair the connectors or wiring harness.
STEP 2. Keyless operation system communication test
Check that the communication with the inside transmission antenna assembly (rear) is normal (Refer to ANTENNA TEST ).

Antennas to be checked

Rear antenna (indoor)

OK: Normal is displayed.

Q: Is the check result normal?
1. YES: Go to Step 3
2. NO: Replace the inside transmission antenna assembly (rear).
STEP 3. Check whether the diagnostic trouble code is stored again.
1. Erase the diagnostic trouble code.
2. Turn the power supply mode of the engine switch from OFF to ON.
3. Check if the diagnostic trouble code is stored.
4. Turn the power supply mode of the engine switch from ON to OFF.
Q: Is the DTC stored?
1. YES: Replace KOS-ECU and register the ID codes (Refer to ON-VEHICLE SERVICE < KOS-ECU > ).
2. NO: Intermittent malfunction is suspected (Refer to HOW TO DEAL WITH INTERMITTENT MALFUNCTION ).