Ignition Switch Continuity Check
WARNING: This page is about a different car, the 2008 Mitsubishi Lancer. However, it is still accessible from the selected car via links, so may be relevant.
With the ignition switch mounted to the vehicle, disconnect and check the ignition switch connection connector.
NORMAL CONDITIONS CHART
| Ignition key position | Terminal number | Normal condition |
|---|---|---|
| LOCK | 1-2, 1-4, 1-5, 1-6 | No continuity |
| ACC | 1-6 | Continuity exists (2 ohms or less) |
| ON | 1-2-4-6 | Continuity exists (2 ohms or less) |
| START | 1-2-5 | Continuity exists (2 ohms or less) |