LEMON Manuals: Even more car manuals for everyone
Home >> Mitsubishi >> 2014 >> Lancer ES Sportback >> Repair and Diagnosis >> External Pages >> Different car >> Section 120 (Chassis Electrical - Lancer Evolution (1 Of 5)) >> Headlight >> On-Vehicle Service >> Customization Function

Customization Function

WARNING: This page is about a different car, the 2008 Mitsubishi Lancer. However, it is still accessible from the selected car via links, so may be relevant.

By operating the ETACS system or MMCS of scan tool MB991958, the following functions can be programmed. The programmed information is held even when the battery is disconnected.

CUSTOMIZATION FUNCTION

Adjustment item (scan tool MB991958 display) Adjustment item Adjusting contents (scan tool MB991958 display) Adjusting contents
ACC power auto cut Time to ACC power cut-off when the ignition switch is in the ACC position Disable No function (default)
30 min 30 minutes
60 min 60 minutes
Turn power source Adjustment of turn-signal light operation condition ACC or IG1 Operable with ACC or ON position
IG1 Operable with ON position (default)
Comfort flasher With/without comfort flasher function Disable No function
Enable With function (default)
Comfort flasher switch time Switch operation time to activate the comfort flasher function Normal 0.4 seconds (default)
Long 0.8 seconds
Hazard answer back Adjustment of the number of keyless hazard warning light answer back flashes Lock:1, Unlock:2 LOCK: Flashes once, UNLOCK: Flashes twice (default)
Lock:1, Unlock:0 LOCK: Flashes once, UNLOCK: No flash
Lock:0, Unlock:2 LOCK: No flash, UNLOCK: Flash twice
Lock:2, Unlock:1 LOCK: Flash twice, UNLOCK: Flash once
Lock:2, Unlock:0 LOCK: Flash twice, UNLOCK: No flash
Lock:0, Unlock:1 LOCK: No flash, UNLOCK: Flash once
Lock:0, Unlock:0 No function
Sensitivity for auto light Lighting control sensor sensitivity (illumination intensity) < vehicles with auto light > Level 1 (+) bright High-high ambient brightness
Level 2 High ambient brightness
Level 3 Standard ambient brightness (default)
Level 4(-)dark Low ambient brightness
Level 5(-)dark Low-low ambient brightness
Headlight auto cut customize Adjustment of headlight automatic shutdown function Disable No function
Enable (C-spec). With function (default)