LEMON Manuals: Even more car manuals for everyone
Home >> Mitsubishi >> 2014 >> Lancer ES Sportback >> Repair and Diagnosis >> External Pages >> Different car >> Section 120 (Chassis Electrical - Lancer Evolution (1 Of 5)) >> Combination Meter >> Troubleshooting >> Check Procedure For Each Multi Information Display Screen >> Other Screens

Other Screens

WARNING: This page is about a different car, the 2008 Mitsubishi Lancer. However, it is still accessible from the selected car via links, so may be relevant.

The screen displays the operation state of each system, periodic checkup timing, or timing for taking a rest during driving. If the screen display differs from the actual system operation state or if the screen is not displayed at the set timing, take measures according to the action procedure.

ACTION PROCEDURE

Display content System operation state Action procedure
G05396740Courtesy of MITSUBISHI MOTOR SALES OF AMERICA.
Displayed when the ASC and S-AWC brake controls are stopped by operating the ASC OFF switch. If the screen is not displayed normally or if the screen continues to be displayed, perform the troubleshooting to the ASC. Refer to TROUBLE SYMPTOM CHART .
G05396741Courtesy of MITSUBISHI MOTOR SALES OF AMERICA.
Displayed when the ASC is in operation. If the warning screen is not displayed normally or if the screen continues to be displayed, perform the troubleshooting for the ASC. Refer to TROUBLE SYMPTOM CHART .
G05396742Courtesy of MITSUBISHI MOTOR SALES OF AMERICA.
When the sporty driving is continued successively, S-AWC control is temporarily suspended to protect the S-AWC device. At this time, the S-AWC mode on the multi information display blinks. If the blinking continues even after the vehicle is driven for a while, perform troubleshooting to the S-AWC system. Refer to TROUBLE SYMPTOM CHART .
G05396743Courtesy of MITSUBISHI MOTOR SALES OF AMERICA.
Displayed when the set period elapses. -
G05396744Courtesy of MITSUBISHI MOTOR SALES OF AMERICA.
Displayed when the set time elapses. -