LEMON Manuals: Even more car manuals for everyone
Home >> Mitsubishi >> 2014 >> Lancer ES Sportback >> Repair and Diagnosis >> External Pages >> Different car >> Section 120 (Chassis Electrical - Lancer Evolution (1 Of 5)) >> Combination Meter >> On-Vehicle Service >> Service Reminder Function Set >> How To Set The Schedule

How To Set The Schedule

WARNING: This page is about a different car, the 2008 Mitsubishi Lancer. However, it is still accessible from the selected car via links, so may be relevant.
  1. Turn the ignition switch to the "OFF" position.
  2. By operating the multi information meter switch, the warning period is displayed on the multi information display.
  3. Press the multi information meter switch once for 1.2 seconds or longer.
  4. The service reminder indicator flashes.
  5. While the service reminder indicator flashes, press the multi information meter switch for 1.2 seconds or longer and 3 times consecutively.
  6. The service reminder indicator is turned ON, and the current schedule is displayed on the multi information display.
  7. While the current schedule is displayed, press the multi information meter switch for less than 1.2 seconds and 3 times consecutively.
  8. The multi information display is shifted to the schedule selection mode.
  9. When the multi information meter switch is pressed for less than 1.2 seconds, the schedule is shifted, and when the multi information meter switch is pressed for 1.2 seconds or longer, the displayed schedule is set.
    NOTE: For schedule, "JPN", "GCC", "EU" and "AUS" can also be selected. However, the setting shall be for "NAS" only.
  10. The schedule set in Step  9 is displayed for 3 seconds, and the warning period to the next time is displayed.
scientia non olet · About LEMON Manuals