LEMON Manuals: Even more car manuals for everyone
Home >> Mitsubishi >> 2014 >> Lancer ES Sportback >> Repair and Diagnosis >> Engine Mechanical >> Mechanical >> Engine Mechanical - 2.0L Non-Turbo - Lancer >> Camshaft >> Removal And Installation >> Installation Service Points >> >> G << Rocker Cover Assembly Installation

>> G << Rocker Cover Assembly Installation

  1. Wipe off the sealant on the mating surface of the rocker cover assembly and cylinder head and timing chain case assembly, and degrease the surface where the sealant is applied.
    CAUTION: After the installation, until a sufficient period of time (one hour or more) elapses, do not apply the oil or water to the sealant application area or start the engine.
  2. Apply sealant to the joint between the cylinder head and timing chain case assembly as shown in the figure and install the rocker cover assembly to the cylinder head.

    Specified sealant: ThreeBond 1227D or equivalent 

    NOTE: Install the rocker cover assembly immediately after applying sealant.
    Fig 1: Identifying Sealant Applying Area To Joint Between Cylinder Head And Timing Chain Case Assembly
    G06480941Courtesy of MITSUBISHI MOTOR SALES OF AMERICA.
  3. Tighten the rocker cover assembly mounting bolts to the specified torque in the order of number shown in the figure.

    Tightening torque: 3.0 ± 1.0 N.m (27 ± 8 in-lb) 

  4. Tighten again the rocker cover assembly mounting bolts to the specified torque in the order of number shown in the figure.

    Tightening torque: 5.5 ± 0.5 N.m (49 ± 4 in-lb) 

    Fig 2: Rocker Cover Assembly Mounting Bolt Tightening Sequence
    G06480942Courtesy of MITSUBISHI MOTOR SALES OF AMERICA.
scientia non olet · About LEMON Manuals