Service Specifications
WARNING: This page is about a different variant/trim than selected.
SERVICE SPECIFICATIONS
| Item | Standard value | Limit | ||
|---|---|---|---|---|
| Rear axle total backlash mm (in) | - | 6 (0.2) | ||
| Wheel bearing end play mm (in) | - | 0.05 (0.002) | ||
| Hub rotation starting torque N.m (in-lb) | - | 1.4 (12.4) | ||
| ETJ boot assembly dimension mm (in) | 80 ± 3 (3.1 ± 0.1) | - | ||
| Drive gear backlash mm (in) | 0.11 -0.16 (0.004 - 0.006) | - | ||
| Drive gear runout mm (in) | - | 0.05 (0.002) | ||
| Drive pinion turning torque N.m (in-lb) | Without oil seal | Bearing (oil seal contacting area) with anti-rust agent | 0.88 -1.17 (7.79 - 10.36) | - |
| Bearing (oil seal contacting area) with gear oil applied | 0.39 -0.49 (3.45 - 4.34) | - | ||
| With oil seal | Companion flange (oil seal contacting area) with anti-rust agent | 0.98 -1.27 (8.67 - 11.24) | - | |
| Companion flange (oil seal contacting area) with gear oil applied | 0.49 -0.58 (4.34 - 5.13) | - | ||
| Right-to-left difference in combined thickness of friction plate and friction disc mm (in) | 0 -0.05 (0 - 0.002) | - | ||
| Clearance between spring plate and differential case mm (in) | 0.06 -0.25 (0.002 - 0.010) | - | ||
| Limited slip differential starting torque N.m (in-lb) | When a new clutch plate is used | 2.1 -2.9 (18.6 - 25.7) | - | |
| When re-installed current clutch plate | 2.1 -2.9 (18.6 - 25.7) | - | ||
| Friction plate and friction disc warping (flatness) mm (in) | - | 0.08 (0.003) | ||
| Friction plate, friction disc and spring plate wear (difference in the thickness of the friction surface and the projections) mm (in) | - | 0.1 (0.004) | ||