LEMON Manuals: Even more car manuals for everyone
Home >> Mitsubishi >> 2010 >> Lancer ES, Standard >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 2 (Rear Axle -- Lancer RALLIART) >> On-Vehicle Service >> Rear Axle Total Backlash Check

Rear Axle Total Backlash Check

WARNING: This page is about a different variant/trim than selected.
  1. Park the vehicle on a flat, level surface.
  2. Move the transmission gearshift lever to the neutral position. Apply the parking brake and jack up the vehicle.
  3. Turn the propeller shaft clockwise as far as it will go. Make the mating marks on the dust cover of the companion flange and on the differential carrier.
    Fig 1: Identifying Mating Marks On Dust Cover Of Companion Flange And Differential Carrier
    G05904381Courtesy of MITSUBISHI MOTOR SALES OF AMERICA.
  4. Turn the propeller shaft counterclockwise as far as it will go, and measure the amount of distance between the mating marks.

    Limit: 6 mm (0.2 inch) 

  5. If the backlash exceeds the limit value, remove the differential carrier assembly and check the following.
Fig 2: Measuring Distance Between Mating Marks
G05904382Courtesy of MITSUBISHI MOTOR SALES OF AMERICA.
scientia non olet · About LEMON Manuals