LEMON Manuals: Even more car manuals for everyone
Home >> Mitsubishi >> 2010 >> Lancer ES, Standard >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 2 (Rear Axle -- Lancer RALLIART) >> On-Vehicle Service >> Gear Oil Replacement

Gear Oil Replacement

WARNING: This page is about a different variant/trim than selected.
  1. Remove the filler plug.
  2. Remove the drain plug and drain oil.
  3. Tighten the drain plug to the specified torque (Refer to EBJ BOOT REPLACEMENT ).
  4. Add the oil until the level comes to the lower portion of the filler plug hole.

    Specified gear oil: MITSUBISHI Genuine DIA QUEEN LSD gear oil 

    Amount to use: Approx. 0.55 dm 3  (0.58 quart) 

  5. Tighten the filler plug to the specified torque (Refer to EBJ BOOT REPLACEMENT ).
scientia non olet · About LEMON Manuals