>>B<< Washer/Rear Driveshaft Nut Installation
WARNING: This page is about a different variant/trim than selected.
CAUTION:
Do not apply the vehicle weight on the rear wheel hub assembly before fully tightening the driveshaft nuts. Otherwise, the wheel bearing will be broken.
- Incorporate the driveshaft washer as shown in the illustration.
- Using special tool MB990767, tighten the driveshaft nut. At this time, tighten the nut to the specified lower limit torque so that the pin hole may align with cotter pin.
Tightening torque: 144 -176 N.m (107 - 129 ft-lb)
- If the pin hole does not align with the pin, tighten the driveshaft nut [less than 176 N.m (129 ft-lb)] and find the nearest hole, then fit the cotter pin.