>>C<< LSD Differential Torque Check

WARNING: This page is about a different variant/trim than selected.

Use the following special tools to check for differential torque.
- Base (MB990989)
- Tool A (MB990990)
Standard value:

<When a new clutch plate is used>:

2.1 - 2.9 N.m (18.6 - 25.7 in-lb)

<When the current clutch plate is reused>:

2.1 - 2.9 N.m (18.6 - 25.7 in-lb)

Fig 1: Checking Differential Torque
Courtesy of MITSUBISHI MOTOR SALES OF AMERICA.

NOTE: Before measuring the differential torque, first turn the gears so they snug each other, then take measurements during rotation.
If the measurement falls outside the specified range, disassemble the differential case assembly and repair or replace defective parts.