LEMON Manuals: Even more car manuals for everyone
Home >> Mitsubishi >> 2010 >> Lancer ES, Standard >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 2 (Rear Axle -- Lancer RALLIART) >> Differential Carrier Assembly >> Disassembly And Assembly >> Assembly Service Points >> >>B<< Screw Tightening

>>B<< Screw Tightening

WARNING: This page is about a different variant/trim than selected.
  1. Align the alignment mark on differential case A with that on differential case B.
  2. Tighten the screws connecting differential case A and B a uniform amount little by little in the diagonal order.
    NOTE: If tightening the screws does not bring the two cases properly together, the spring plates are not probably assembled properly. Reassemble from the start.
Fig 1: Checking Alignment Marks
G05904455Courtesy of MITSUBISHI MOTOR SALES OF AMERICA.
scientia non olet · About LEMON Manuals