LEMON Manuals: Even more car manuals for everyone
Home >> Mitsubishi >> 2010 >> Lancer ES, Standard >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 2 (Rear Axle -- Lancer RALLIART) >> Differential Carrier Assembly >> Assembly >> Assembly Service Points >> >>F<< Drive Gear Installation

>>F<< Drive Gear Installation

WARNING: This page is about a different variant/trim than selected.
  1. Clean the drive gear attaching bolts.
  2. Remove the adhesive adhered to the threaded holes of the drive gear by turning the tap (M10 x 1.25). Clean the threaded holes by applying compressed air.
    Fig 1: Removing Adhesive Adhered To Threaded Holes Of Drive Gear
    G05904447Courtesy of MITSUBISHI MOTOR SALES OF AMERICA.
  3. Apply the specified adhesive to the threaded holes of the drive gear.

    Specified adhesive: 3M ™ AAD Part No. 8730, 8731 or equivalent 

  4. Install the drive gear onto the limited slip differential case with the mating marks properly aligned. Tighten the drive gear attaching bolts to the specified torque in a diagonal sequence.

    Tightening torque: 84 ± 4 N.m (62 ± 2 ft-lb) 

    Fig 2: Applying Specified Adhesive To Threaded Holes Of Drive Gear
    G05904448Courtesy of MITSUBISHI MOTOR SALES OF AMERICA.
scientia non olet · About LEMON Manuals