SYMPTOM CHART - Vehicles Without A/C

WARNING: This page is about a different car, the 2012 Mitsubishi Lancer. However, it is still accessible from the selected car via links, so may be relevant.

CAUTION: During diagnosis, a DTC code associated with other system may be set when the ignition switch is turned on with connector(s) disconnected. On completion, confirm all systems for DTC code(s). If DTC code(s) are set, erase them all.

SYMPTOM CHART

Symptom	Inspection procedure
Malfunction of the A/C power supply system. <Vehicles without A/C>	Refer to INSPECTION PROCEDURE 1: MALFUNCTION OF THE HEATER CONTROL UNIT POWER SUPPLY SYSTEM. <VEHICLES WITHOUT A/C>
Blower fan and motor do not turn. <Vehicles without A/C>	Refer to INSPECTION PROCEDURE 2: BLOWER FAN AND MOTOR DO NOT TURN. <VEHICLES WITHOUT A/C>
Blower air amount cannot be changed. <Vehicles without A/C>	Refer to INSPECTION PROCEDURE 3: BLOWER AIR AMOUNT CANNOT BE CHANGED. <VEHICLES WITHOUT A/C>
Outside/inside air changeover is not possible. <Vehicles without A/C>	Refer to INSPECTION PROCEDURE 4: OUTSIDE/INSIDE AIR CHANGEOVER IS NOT POSSIBLE <VEHICLES WITHOUT A/C>
A/C outlet air temperature does not increase. <Vehicles without A/C>	Refer to INSPECTION PROCEDURE 5: A/C OUTLET AIR TEMPERATURE DOES NOT INCREASE <VEHICLES WITHOUT A/C>
Air outlet vent cannot be changed. <Vehicles without A/C>	Refer to INSPECTION PROCEDURE 6: AIR OUTLET VENT CANNOT BE CHANGED. <VEHICLES WITHOUT A/C>
Blower motor power supply system. <Vehicles without A/C>	Refer to INSPECTION PROCEDURE 7: BLOWER MOTOR POWER SUPPLY SYSTEM. <VEHICLES WITHOUT A/C>