Power Door Locks With Selective Unlocking Inspection

WARNING: This page is about a different car, the 2012 Mitsubishi Lancer. However, it is still accessible from the selected car via links, so may be relevant.

Check the power door locks with selective unlocking as described below. If it does not work, perform troubleshooting. Refer to TROUBLE SYMPTOM CHART .

NOTE: The setting of the power door locks with selective unlocking can be changed using the customization function. Confirm which setting is activated before performing these checks. Refer to CUSTOMIZATION FUNCTION .

Press the unlock button on the keyless operation key once to unlock only the driver's door. Press the unlock button of the keyless operation key once again within 2 seconds after the driver's door is unlocked, and check that the front passenger's door, rear doors are unlocked.
NOTE: Press the unlock button on the keyless operation key once to unlock only the driver's door. When the unlock button of the keyless operation key is pressed once again more than 2 seconds after the driver's door is unlocked, only the driver's door is unlocked.
Press the lock/unlock switch on the door outside handle (driver's side) once to unlock only the driver's door. Press the lock/unlock switch of the door outside handle (driver's side) once again within 2 seconds after the driver's door is unlocked, and check that the front passenger's door, rear doors are unlocked.

NOTE: Press the lock/unlock switch on the door outside handle (driver's side) once to unlock only the driver's door. When the lock/unlock switch of the door outside handle (driver's side) is pressed once again more than 2 seconds after the driver's door is unlocked, only the driver's door is unlocked.