INSPECTION PROCEDURE 6: Outside/Inside Air Changeover is not possible: Diagnosis

Required Special Tools: 

• MB991223: Harness Set
• MB992006: Extra Fine Probe
• MB991958: Scan Tool (M.U.T.-III Sub Assembly)
  • MB991824: V.C.I.
  • MB991827: M.U.T.-III USB Cable
  • MB991910: M.U.T.-III Main Harness A

1. STEP 1. Using scan tool MB991958, check for diagnostic trouble code. 
   CAUTION: To prevent damage to scan tool MB991958, always turn the ignition switch to the "LOCK" (OFF) position before connecting or disconnecting scan tool MB991958.

   Check if an A/C-ECU DTC is set.

   1. Connect scan tool MB991958. Refer to "HOW TO CONNECT THE SCAN TOOL (M.U.T.-III)  ".
   2. Turn the ignition switch to the "ON" position.
   3. Check if the DTC is set.
   4. Turn the ignition switch to the "LOCK" (OFF) position.

   Q: Is the DTC set? 

   YES  : Refer to DIAGNOSTIC TROUBLE CODE CHART  .

   NO  : Go to Step 2.

2. STEP 2. Check outside/inside air selection damper control motor connector C-111 and A/C-ECU connector C-20 for loose, corroded or damaged terminals, or terminals pushed back in the connector. 

   Q: Are outside/inside air selection damper control motor connector C-111 and A/C-ECU connector C-20 in good condition? 

   YES  : Go to Step 3.

   NO  : Repair or replace the connector. Refer to HARNESS CONNECTOR INSPECTION . Check that the A/C works normally.

   Fig 1: Connecting Special Tool To Data Link Connector

   Courtesy of MITSUBISHI MOTOR SALES OF AMERICA.
3. STEP 3. Check the wiring harness between A/C-ECU connector C-20 (terminal 26, 25, 27, 24 and 29) and outside/inside air selection damper control motor connector C-111 (terminals 2, 5, 4. 1 and 3). 

   Q: Are the wiring harness between A/C-ECU connector C-20 (terminal 26, 25, 27, 24 and 29) and outside/inside air selection damper control motor connector C-111 (terminals 2, 5, 4. 1 and 3) in good condition? 

   YES  : Go to Step 4.

   NO  : Repair the wiring harness. Check that the A/C works normally.

4. STEP 4. Replace the outside/inside air selection damper control motor and check the trouble symptom again 

   Check the trouble symptom again.

   Q: Is the check result satisfactory? 

   YES  : The procedure is complete.

   NO  : Replace the A/C-ECU.