Diagnostic Trouble Code Chart
WARNING: This page is about a different car, the 2008 Mitsubishi Lancer. However, it is still accessible from the selected car via links, so may be relevant.
CAUTION:
During diagnosis, a DTC code associated with other system may be set when the ignition switch is turned on with connector(s) disconnected. On completion of repairs, check all systems for DTC code(s). If DTC code(s) are set, erase them all.
DIAGNOSTIC TROUBLE CODE CHART
| Diagnostic trouble code No. | Diagnostic item |
|---|---|
| B10C0 | Interior temperature sensor system (short circuit) |
| B10C1 | Interior temperature sensor system (open circuit) |
| B1000 | Control panel communication error |
| B1003 | Mode dial SW error |
| B1018 | Temperature control dial SW error |
| B1021 | Fan dial SW error |
| B1031 | Fin thermo sensor system (short circuit) |
| B1032 | Fin thermo sensor system (open circuit) |
| B1034 * | Ambient air temperature sensor system (short circuit) |
| B1035 * | Ambient air temperature sensor system (open circuit) |
| B1079 | Refrigerant leaks |
| B2214 | Control panel failure |
| B223B | Control panel improperly assembled |
| U1415 | Coding not completed |
| U0019 | Bus off (CAN1) |
| U0141 | ETACS-ECU time-out |
| U0151 | SRS-ECU time-out |
| U0154 | Occupant classification-ECU time-out |
| U0155 | Combination meter time-out |
| U0168 | WCM time-out |
| U0184 | Audio time-out |
| U0195 | Satellite radio tuner time-out |
| U0197 | Hands free module time-out |
| U0245 | Audio visual navigation unit CAN timeout |
|
NOTE:
The diagnostic trouble codes marked by * are set from the ETACS-ECU.
|
|