Sensor Check

WARNING: This page is about a different car, the 2008 Mitsubishi Lancer. However, it is still accessible from the selected car via links, so may be relevant.

The speed sensor and gyro sensor will be checked, depending on the vehicle conditions such as driving condition, stationary condition and travel direction change.

Select "Sensor Check" on "Service" screen.

Fig 1: Scan Tool Display - Sensor Check
Courtesy of MITSUBISHI MOTOR SALES OF AMERICA.
The sensor check with the vehicle stationary will be executed in accordance with the screen.

Fig 2: Scan Tool Display - Sensor Check
Courtesy of MITSUBISHI MOTOR SALES OF AMERICA.

Fig 3: Scan Tool Display - Sensor Check
Courtesy of MITSUBISHI MOTOR SALES OF AMERICA.
The sensor check with the vehicle in motion will be executed in accordance with the screen.

Fig 4: Scan Tool Display - Sensor Check
Courtesy of MITSUBISHI MOTOR SALES OF AMERICA.

When the sensor checks are complete, the screen will display the check results.

Fig 5: Scan Tool Display - Sensor Check

Courtesy of MITSUBISHI MOTOR SALES OF AMERICA.

NOTE: If there is "NG" or "N/A" as the check results, select "NG Code" on the "Sensor Check" screen. Then "NG code Indication" screen will show the NG code.

NG CODE REFERENCE TABLE FOR SENSOR CHECK

SENSOR CLASSIFICATION CHART

Sensor classification	NG code No.	Error items
Gyro sensor	1	Offset error while the vehicle is stationary (lower limit error)
	2	Offset error while the vehicle is stationary (upper limit error)
	5	Output error during driving
Speed sensor	6	Output error while the vehicle is stationary

Fig 6: Scan Tool Display - NG Code Indication

Courtesy of MITSUBISHI MOTOR SALES OF AMERICA.