>>F<< Camshaft Bearing/Camshaft And Camshaft Sprocket Assembly (Exhaust Side) Installation

CAUTION:

Be careful not to drop the camshaft bearing.
When installing the camshaft and camshaft sprocket assembly (exhaust side), be careful not to let the camshaft bearing which is installed to the front cam bearing cap deviate from its position.

When replacing the camshaft bearing, according to the identification mark of front camshaft bearing cap in the table below, select a camshaft bearing with the corresponding size. Note that the identification mark of camshaft bearing is stamped on the place shown in the illustration.

FRONT CAMSHAFT BEARING CAP SPECIFICATION CHART

Front camshaft bearing cap		Camshaft bearing identification mark
Identification mark	Journal diameter mm (in)	Camshaft bearing identification mark
1	40.000 - 40.008 (1.5748 - 1.5751)	1
2	40.008 - 40.016 (1.5751 - 1.5754)	2
3	40.016 - 40.024 (1.5754 - 1.5757)	3

Fig 1: Identifying Front Camshaft Bearing Cap And Identification Mark

Courtesy of MITSUBISHI MOTOR SALES OF AMERICA.

Fig 2: Identifying Front Camshaft Bearing Identification Mark And Oil Hole

Courtesy of MITSUBISHI MOTOR SALES OF AMERICA.