Radio And Cd Player -- Lancer
- General Information
- Special Tools
- Diagnosis
- Introduction To Audio System Diagnosis
- Standard Flow Of Diagnostic Troubleshooting
- Diagnosis Function
- Diagnostic Trouble Code Chart
- Diagnostic Trouble Code Procedures
- DTC U0019: Bus off (CAN-B)
- DTC U0141: ETACS CAN timeout
- DTC U0151: SRS-ECU CAN timeout
- DTC U0154: OCM (occupant classification-ECU) CAN timeout
- DTC U0155: Meter CAN timeout
- DTC U0164: A/C CAN timeout
- DTC U0168: WCM CAN timeout
- DTC U0195: Satellite radio CAN timeout
- DTC U0197: Hands free module CAN timeout
- DTC U1415: Coding not completed/Data fail
- DTC B2420: Power integrated circuit
- DTC B2421: Radio tuner
- DTC B2423: 6 CD player error
- DTC B2424: CD player error
- DTC B2450: Switch panel communication
- DTC B2451: Audio panel type error
- Trouble Symptom Chart
- Symptom Procedures
- Inspection Procedure 1: Power of the radio and CD player does not turn ON when the Ignition switch is in the "ACC" position or "ON" Position
- Inspection Procedure 2: No sound is heard.
- Inspection Procedure 3: No sound is heard from one of the speakers.
- Inspection Procedure 3: No sound is heard from one of the speakers.
- Inspection Procedure 4: The audio does not operate normally by operating the radio and CD player of the center panel unit
- Inspection Procedure 5: Audio illuminations does not work normally
- Inspection Procedure 6: The sound of external input are not played
- INSPECTION PROCEDURE 7: Noise Appears at Certain Places When Traveling (AM)
- INSPECTION PROCEDURE 8: Noise is Present while Moving (FM)
- INSPECTION PROCEDURE 9: Sound mixed with Noise, Only at Night (AM)
- INSPECTION PROCEDURE 10: Broadcasts can be Heard but Both AM and FM have a lot of Noise
- INSPECTION PROCEDURE 11: There is More Noise on either AM or FM
- INSPECTION PROCEDURE 12: Noise Sometimes Appears on FM During Traveling
- INSPECTION PROCEDURE 13: There is Noise when Starting the Engine
- INSPECTION PROCEDURE 14: Some Noise Appears When There is Vibration or Shocks during Traveling
- INSPECTION PROCEDURE 15: Ever-present Noise
- INSPECTION PROCEDURE 16: Noise Comes Out, but neither AM nor FM Sounds
- INSPECTION PROCEDURE 17: Poor Reception
- INSPECTION PROCEDURE 18: Distortion on AM or on Both AM and FM
- INSPECTION PROCEDURE 19: Distortion on FM Only
- INSPECTION PROCEDURE 20: Using the Auto Select Function, too Few Automatic Stations are Selected
- INSPECTION PROCEDURE 21: Preset Stations are Erased
- INSPECTION PROCEDURE 22: CD can not be Inserted
- INSPECTION PROCEDURE 23: No Sound. (CD Only)
- INSPECTION PROCEDURE 24: CD Sound Skips
- INSPECTION PROCEDURE 25: Sound Quality is Poor
- INSPECTION PROCEDURE 26: CD can not be Ejected
- On-Vehicle Service
- Removal And Installation
- Inspection