INSPECTION PROCEDURE 6: Speedometer does not work (other meters work); INSPECTION PROCEDURE 7: The fuel gauge needle moves excessively: Diagnosis

Required Special Tools:

MB991958: Scan Tool (M.U.T.-III Sub Assembly)
- MB991824: V. C. I.
- MB991827: M.U.T.-III USB Cable
- MB991910: M.U.T.-III Main Harness A

STEP 1. Using scan tool MB991958, diagnose the CAN bus line.
CAUTION: To prevent damage to scan tool (MB991958), always turn the ignition switch to the "LOCK" (OFF) position before connecting or disconnecting scan tool (MB991958).
1. Connect scan tool MB991958 to the data link connector.
2. Turn the ignition switch to "ON" position.
3. Diagnose the CAN bus line.
4. Turn the ignition switch to the "LOCK" (OFF) position.
Q: Is the check result satisfactory?
1. YES : Go to Step 2.
2. NO : Repair the CAN bus lines (Refer to CAN BUS DIAGNOSTIC CHART ).
Fig 1: Connecting Special Tool MB991910 To Data Link Connector
Courtesy of MITSUBISHI MOTOR SALES OF AMERICA.
STEP 2. Using scan tool MB991958, read MFI diagnostic trouble code.
Check if an MFI system diagnostic trouble code is set.
1. Turn the ignition switch to "ON" position.
2. Diagnose the CAN bus line.
3. Turn the ignition switch to the "LOCK" (OFF) position.
Q: Is the DTC set?
1. YES : Refer to DIAGNOSTIC TROUBLE CODE CHART <2.4L ENGINE> or DIAGNOSTIC TROUBLE CODE CHART <3.8L ENGINE>.
2. NO : Go to Step 3.
Fig 2: Connecting Special Tool MB991910 To Data Link Connector
Courtesy of MITSUBISHI MOTOR SALES OF AMERICA.
STEP 3. Using scan tool MB991958, check data list.
1. Turn the ignition switch to the "ON" position.
2. Set scan tool MB991958 to the data reading mode.
  - Item 54: Speedometer (Input)
    - Speedometer and M.U.T.-III displayed values agree with each other.
  - Turn the ignition switch to the "LOCK" (OFF) position.
  Q: Is the measured voltage equal to battery positive voltage?
  1. YES : It can be assumed that this malfunction is intermittent. Refer to HOW TO COPE WITH INTERMITTENT MALFUNCTION .
  2. NO : Go to Step 4.
Fig 3: Connecting Special Tool MB991910 To Data Link Connector
Courtesy of MITSUBISHI MOTOR SALES OF AMERICA.
STEP 4. Using scan tool MB991958, check actuator test.
Use scan tool MB991958 to enter simulated vehicle speed.
1. Turn the ignition switch to "ON" position.
2. Select "Interactive Diagnosis" from the start-up screen.
3. Select "System Select."
4. Choose "Meter" from the "BODY" tab.
5. Select "Simulated vehicle Speed Output."
  OK: The speedometer shows the simulated vehicle speed.
6. Turn the ignition switch to the "LOCK" (OFF) position.
Q: Is the check result satisfactory?
1. YES : Go to Step 5.
2. NO : Replace the combination meter.
Fig 4: Connecting Special Tool MB991910 To Data Link Connector
Courtesy of MITSUBISHI MOTOR SALES OF AMERICA.
STEP 5. Retest the system.
Check that the speedometer works normally.

Q: Is the check result satisfactory?
1. YES : The procedure is complete. (If no malfunctions are found in all steps, an intermittent malfunction is suspected. Refer to HOW TO COPE WITH INTERMITTENT MALFUNCTION ).
2. NO : Replace the combination meter.