Sensor Check

The speed sensor and gyro sensor will be checked, depending on the vehicle conditions such as driving condition, stationary condition and travel direction change.

1. Select "Sensor Check" on "Service" screen.
   Fig 1: Screen Display - Service

   Courtesy of MITSUBISHI MOTOR SALES OF AMERICA.
2. The sensor check with the vehicle stationary will be executed in accordance with the screen.
   Fig 2: Screen Display - Sensor Check

   Courtesy of MITSUBISHI MOTOR SALES OF AMERICA.
   Fig 3: Screen Display - Sensor Check

   Courtesy of MITSUBISHI MOTOR SALES OF AMERICA.
3. The sensor check with the vehicle in motion will be executed in accordance with the screen.
   Fig 4: Screen Display - Sensor Check

   Courtesy of MITSUBISHI MOTOR SALES OF AMERICA.
4. When the sensor checks are complete, the screen will display the check results.
   Fig 5: Screen Display - Sensor Check

   Courtesy of MITSUBISHI MOTOR SALES OF AMERICA.
   NOTE: If there is "NG" or "N/A" as the check results, select "NG Code" on the "Sensor Check" screen. Then "NG code Indication" screen will show the NG code.