Inspection Procedure 8: Wind Noise Around Door: Diagnosis
WARNING: This page is about a different variant/trim than selected.
- STEP 1. Check the weatherstrip for holding condition.
Q: Is the weatherstrip holding firmly?
YES: Go to Step 2.
NO: Adjust fit of door (Refer to GLASS SLIDING MECHANISM CHECK AND ADJUSTMENT ). Then go to Step 5.
- STEP 2. Check the weatherstrip for installation condition.
Q: Is the weatherstrip installed properly?
YES: Go to Step 3.
NO: Repair or replace the weatherstrip. Then go to Step 5.
- STEP 3. Check the clearance.
Q: Are the door glass and door weatherstrip holder installed properly?
YES: Go to Step 4.
NO: Adjust the door glass and the weatherstrip holder (Refer to GLASS SLIDING MECHANISM CHECK AND ADJUSTMENT ). Then go to Step 5.
- STEP 4. Check the door for deformation.
Q: Is the door deformed?
YES: Replace the door. then go to Step 5.
NO: Go to Step 5.
- STEP 5. Retest the system.
Q: Has the wind noise been improved?
YES: Return to Step 1.
NO: The diagnosis complete.