Inspection Procedure 3: Water Leak Through Door Edge: Diagnosis
WARNING: This page is about a different variant/trim than selected.
- STEP 1. Check the weatherstrip.
Q: Is the weatherstrip in good condition?
YES: Go to Step 2.
NO: Replace the weatherstrip, then go to Step 3.
- STEP 2. Check the door fit (alignment).
Q: Is the door fit (alignment) correct?
YES: Go to Step 3.
NO: Adjust the door fit (Refer to DOOR FIT ADJUSTMENT ). Then go to Step 3.
- STEP 3. Retest the system.
Q: Is any water leaking?
YES: Return to Step 1.
NO: The procedure is complete.