Inspection Procedure 5: Faulty Abs Operation: Diagnosis
WARNING: This page is about a different variant/trim than selected.
- STEP 1. Hydraulic unit check
Refer to HYDRAULIC UNIT CHECK .
Q: Is the hydraulic unit normal?
YES: Go to Step 2.
NO: Connect the brake pipes correctly, repair the external brake lines, or replace the hydraulic unit.
- STEP 2. Verify that the condition described by the customer exists.
Q: Can any faults be found with the brake operation?
YES: Check the brake system related components except the ABS system.
NO: The procedure is complete.