TROUBLESHOOTING HINTS (The most likely causes for these DTCs are to set are:)

WARNING: This page is about a different variant/trim than selected.

Current trouble

Damaged wiring harness or connector
Malfunction of the hydraulic unit (integrated with ABS-ECU)

Past trouble

Carry out diagnosis with particular emphasis on connector(s) or wiring harness between the power supply circuit (terminal 1) to the ABS-ECU solenoid valve or ground circuit (terminal 2) . For diagnosis procedures, refer to "How to cope with past trouble" (Refer to HOW TO USE TROUBLESHOOTING/INSPECTION SERVICE POINTS ).