TROUBLESHOOTING HINTS (The most likely causes for these DTCs are to set are:)
WARNING: This page is about a different variant/trim than selected.
Current trouble
- Damaged wiring harness or connector
- Malfunction of the hydraulic unit (integrated with ABS-ECU)
Past trouble
- Carry out diagnosis with particular emphasis on connector(s) or wiring harness between the power supply circuit (terminal 19) to the ABS-ECU motor or ground circuit (terminal 18). For diagnosis procedures, refer to "How to cope with past trouble" (Refer to HOW TO USE TROUBLESHOOTING/INSPECTION SERVICE POINTS ).