Abs DTC Set Conditions

WARNING: This page is about a different variant/trim than selected.

These diagnostic trouble codes will be set under the cases below.

DTC C1266: Motor system (seizure)

This DTC is set when the ECU determines the pump motor is not running smoothly (i.e. motor seizure) by the motor relay ON/OFF.

DTC C1273: Motor relay problem (stuck off)

If the ABS-ECU determines that the motor is not running after the motor relay is turned on, the ECU determines that the motor relay is stuck off, and sets this DTC.

DTC C1274: Motor relay problem (stuck on)

If the ABS-ECU determines that the motor is running after the motor relay is turned off, the ECU determines that the motor relay is stuck on, and sets this DTC.