Removal & Installation (FWD Models)
- Raise and support vehicle. Remove wheels. Remove wheel speed sensor (if equipped). On models with drum brakes, remove brake drum and shoes. See REAR BRAKE DRUM & SHOES .
- On models with disc brakes, remove caliper and rotor. On all models, remove hub bolts or spindle nut and hub assembly. To install, reverse removal procedure. Tighten hub bolts or spindle nut to specification. See HUB TIGHTENING TORQUE table. Rotate brake drum or disc to ensure free movement.
NOTE:
Rear hub bearings are not serviceable on Eclipse AWD models.