LEMON Manuals: Even more car manuals for everyone
Home >> Mitsubishi >> 1990 >> Eclipse Base, Standard >> Repair and Diagnosis >> Engine Mechanical >> Mechanical >> 1.8L 4-CYL - VIN (T), 2.0L VIN (R,U,V) & 2.4L VIN (W) 4-Cylinder >> Removal & Installation >> Cylinder Head >> Installation (2.4L)

Installation (2.4L)

  1. Install cylinder head using new gasket. Ensure identification mark at timing belt end of gasket faces upward. DO NOT apply sealant to head gasket. Install and tighten cylinder head bolts (in 2-3 steps) to specification in proper sequence. See Fig 1. See TORQUE SPECIFICATIONS - 2.4L .
  2. To install remaining components, reverse removal procedure. Apply sealant to contact surfaces of semi-circular packing. Adjust all control cables. Fill cooling system.
Fig 1: Cylinder Head Bolt Removal & Installation Sequence (2.4L)
G90I08811Courtesy of CHRYSLER MOTORS.
scientia non olet · About LEMON Manuals