35 11 000 Removing and installing complete bearing bracket for foot pedal
Preliminary work needed :
- Read and comply with GENERAL INFORMATION .
- Remove BRAKE BOOSTER .
Disconnect plug connection (1) on clutch master cylinder.
Disconnect line connection (2).
IMPORTANT:
Catch brake fluid in a suitable container.
Disconnect plug connection (1) on brake light switch.
Undo nut (2) and remove bearing bracket (3).
Installation note :
Tightening torque 35 11 AZ .
Installation :
IMPORTANT:
If required the clutch pedal must be remounted depending on the version of the new bearing block!
This operation is described in: REMOVING AND INSTALLING CLUTCH PEDAL .
Install bearing bracket (3).
Fit nut (2) and tighten.
Replace self-locking nuts.
Parts : Nut
Tightening torque 35 11 AZ .
Connect plug connection (1) on brake light switch.
Connect line connection (2).
Connect plug connection (1) on clutch master cylinder.
Required follow-up work :
- Install the BRAKE BOOSTER .
- Vent the CLUTCH AND BRAKE HYDRAULICS .