12 51 240 Remove and install/replace Module 2, sensor system engine wiring (Countryman base FWD, Countryman base ALL4 AWD)

Preliminary work 

• Refer to DISCONNECTING ALL BATTERY GROUND LEADS .
• Refer to REMOVING REAR HOOD SEAL .
• Refer to REMOVING FRONT WINDSHIELD PANEL COVER .
• Refer to REMOVING SUSPENSION CROSS-BRACE .
• Refer to REMOVING THE UPPER BULKHEAD COVER PANEL .
• Refer to REMOVING THE REAR BULKHEAD .
• Refer to REMOVING THE ACOUSTIC COVER .
• Refer to REMOVING CLEAN AIR PIPE .

Follow-up work 

• Refer to INSTALLING CLEAN AIR PIPE .
• Refer to INSTALLING ACOUSTIC COVER .
• Refer to INSTALLING THE REAR BULKHEAD .
• Refer to INSTALLING THE UPPER BULKHEAD COVER PANEL .
• Refer to INSTALLING THE STRUT BRACE .
• Refer to INSTALLING FRONT WINDSHIELD PANEL COVER .
• Refer to INSTALLING THE FRONT HOOD SEAL AT THE REAR .
• Refer to CONNECTING ALL BATTERY GROUND LEADS .