FRONT PANEL INSTALLATION PROCEDURE REP-REP-RAF5641-4133XX1 - V.6 (Countryman 2017-2023, except PHEV)

To avoid unnecessary adjustment work, apply the following procedure.

Observe FRAME REFERENCE BODY DIMENSION REP-UEB-RAF5441-4106100 - V.3 (COUNTRYMAN 2017-2023, EXCEPT PHEV) .

Courtesy of BMW OF NORTH AMERICA, INC.

Step 1: Setting of DEFORMATION ELEMENT .

Set the deformation element (1) so that the areas (3) are parallel.

NOTE: The deformation element cannot be height-adjusted because of the stop (2).

Courtesy of BMW OF NORTH AMERICA, INC.

Step 2: Setting of "cross connection support. Refer to 41 33 731 REPLACE THE SUPPORT FOR THE RIGHT CROSS CONNECTION (DEFORMATION ELEMENT REMOVED) REP-REP-RAF6041-4133731 - V.1 (Countryman 2017-2023, except PHEV) "

Set the cross connection support (1) according to the specified dimensions.

Dimension a = approx. 3 mm.

NOTE: If the cross connection support is removed on only one side of the vehicle, measure dimension a on the side where it has not been removed and apply it as the setting dimension.

Tighten all screw connections with TIGHTENING TORQUE .