Installing the oil-level sensor for engine oil
- Replace sealing ring (1).
Parts: Sealing ring
- Clean sealing surface on oil sump.
- Insert and install the oil-level sensor (3).
- Tighten nuts (2).
TIGHTENING TORQUES SPECIFICATION
| Oil level sensor to oil sump | ||
| M6 hexagon nut | Joining torque | 2Nm |
| Tightening torque | 8Nm | |
- Connect and lock the connector (1).
The connector (1) must lock audibly.
Follow-up work
- Refer to TIGHTENING THE OIL DRAIN PLUG .
- Refer to INSTALLING FRONT UNDERBODY PROTECTION .
- Refer to TOPPING UP THE MOTOR OIL .