33 32 086 Removing and installing/replacing bottom left wishbone (Countryman models with AWD, except PHEV)

Preliminary work needed: 

• Remove REAR WHEEL .
• Remove exhaust system.

Removal: 

Remove rear heat shield (1).

Courtesy of BMW OF NORTH AMERICA, INC.

Mark position of eccentric shim to trailing arm to simplify subsequent adjustment of rear axle.

Release nut and remove screw (2).

Slacken nut (1).

Remove eccentric washer and unscrew screw.

Remove wishbone (3).

Installation note: 

Tighten screw connection (1) and (2) in NORMAL POSITION .

Courtesy of BMW OF NORTH AMERICA, INC.

Installation: 

Align wishbone (3).

Insert bolt (1) and connect eccentric shim.

Align eccentric shim to marked position.

Part:  Replace screw and nut (1).

Tighten nut (1) in NORMAL POSITION (not until wheel alignment).

Tightening torque 33 32 2AZ .

Part:  Replace nut.

Insert bolt (2) and screw on new nut.

• Do not yet tighten to specified torque!

Shift vehicle into NORMAL POSITION .

Tighten nut of bolt (2) in normal position.

Tightening torque 33 32 3AZ .

Courtesy of BMW OF NORTH AMERICA, INC.

Mount heat shield (1).

Courtesy of BMW OF NORTH AMERICA, INC.

Required follow-up work: 

• Mount exhaust system.
• Install REAR WHEEL .
• Perform wheel alignment. Refer to 32 00 150 KDS CHASSIS/WHEEL ALIGNMENT CHECK WITH VEHICLE LOAD UP TO DESIGN POSITION (COUNTRYMAN 2017-2023, EXCEPT PHEV) or 32 00 155 KINEMATICS DIAGNOSIS SYSTEM WHEEL ALIGNMENT WITH RIDE HEIGHT MEASUREMENT WITHOUT LOADING THE VEHICLE (COUNTRYMAN 2017-2023, EXCEPT PHEV) .