Shifting vehicle into normal position (Countryman 2017-2023, except PHEV)
Preliminary work needed:
- Check compliance with TEST CONDITIONS , repair vehicle if necessary.
- Check vehicle interior and trunk (including spare wheel well) for load status, if applicable, unload car
- Introduce DIN load into vehicle.
Vehicle fully assembled for normal driving with: 2 x 68 kg on the front seats (seats in center position), 1 x 68 kg on the rear bench seat, 1x 21 kg in the luggage compartment (center) and full fuel tank. - Determine VEHICLE RIDE HEIGHT .
NOTE:
If the vehicle ride height is not inside the tolerance (refer to TECHNICAL DATA
), the vehicle must be repaired (coil spring/leakage).