Install roller sunblind

• Make sure the cables (2) are correctly fitted on the strip (1).
• Carefully insert the strip (1) into the rails.

  Courtesy of BMW OF NORTH AMERICA, INC.

• Guide the roller sunblind under the sliders (1) and clip it into the holders (2) from the back.
• Make sure roller sunblind is correctly positioned in side rails.

Courtesy of BMW OF NORTH AMERICA, INC.

• If necessary, attach the cable (1) to the roller sunblind.

  Depending on the position, the cable (1) must be attached on the inside or the outside.

  When retracting the cable, it must be positioned in the notch (arrow).

  Courtesy of BMW OF NORTH AMERICA, INC.

• Attach both cables (1) to the idler pulleys (2).
• Hold both cables under tension.
• Make sure that the cables (1) are correctly positioned in the rail (3).

  Courtesy of BMW OF NORTH AMERICA, INC.

• Hold both cables under tension and remove the holding fixture (1).
• Slowly move back both cables.

  Courtesy of BMW OF NORTH AMERICA, INC.

• Slide the slider (1) into the strip (2) and engage it.
• Make sure the detent (3) is correctly positioned.

  Courtesy of BMW OF NORTH AMERICA, INC.

• Make sure the cable (1) is correctly positioned in the area of the holders (2).
• Carry out functional check.

Courtesy of BMW OF NORTH AMERICA, INC.

Follow-up work 

• Refer to INSTALL REAR GLASS SLIDE/TILT SUNROOF PANEL .
• Refer to INSTALLING THE FRONT GLASS SLIDE/TILT SUNROOF PANEL .
• Refer to CHECKING THE SETTING OF THE PANORAMA GLASS ROOF .
• Refer to ADJUSTING FRONT GLASS SLIDE/TILT SUNROOF PANEL .
• Refer to INITIALIZE PANORAMA GLASS ROOF .