65 12 320 Removing and installing (replacing) Headunit Basis - V.3 (Countryman 2017-2023, except PHEV)

Important: 

Risk of damage!

There is a hard disk installed in the headunit.

Carry out mechanical work on the headunit and adjacent components with vehicle care.

Avoid subjecting the headunit to vibration/shocks.

Important: 

Read and comply with NOTES on protection against electrostatic damage (ESD protection).

Preliminary work needed: 

• Remove CENTRAL INSTRUMENT .
• DISCONNECT cable from battery earth lead

Removal: 

Unscrew the screws (1).

Courtesy of BMW OF NORTH AMERICA, INC.

Unlock plug connections. (1) and disconnect.

Remove headunit (2).

Courtesy of BMW OF NORTH AMERICA, INC.

Replacement: 

Unscrew the screws (1).

Take off holder (2).

Courtesy of BMW OF NORTH AMERICA, INC.

Installation: 

Connect and lock all plug connections (1).

Position headunit (2).

Courtesy of BMW OF NORTH AMERICA, INC.

Tighten down screws (1).

Courtesy of BMW OF NORTH AMERICA, INC.

Only for US version with SDARS: 

Additional work is required when replacing the headunit!

• Refer to REPLACING SDARS, AS OF 09/2009 .

Required reworking: 

• Install CENTRAL INSTRUMENT .
• Connect BATTERY GROUND LEAD .

Replacement: 

Carry out PROGRAMMING/CODING .

ON VEHICLES WITH A PRODUCTION DATE AS FROM 07/2015, INSTALL THE CORRECT NAVIGATION MAP .

Importing the Service history: 

• 05 Maintenance and Pre-Delivery Check
• Service history