51 47 314 Removing and installing/replacing carpet for passenger compartment (Cooper 2-door hatchback models, 2020-2023)

Preliminary work needed:

Release end lining on front bottom of SAFETY BELT .
Remove both front seats. Refer to 52 13 001 REMOVING AND INSTALLING FRONT SEAT, DRIVER'S SIDE (COOPER 4-DOOR HATCHBACK MODELS, 2020-2023) and 52 13 002 REMOVING AND INSTALLING FRONT SEAT, PASSENGER'S SIDE (COOPER 2-DOOR HATCHBACK MODELS, 2020-2023) .
Remove BASS SPEAKER .
Remove AIRBAG CONTROL UNIT .
Remove FUNCTION CARRIER DASHBOARD .
Remove REAR SEAT .
Remove accelerator pedal module
Release REAR TRIM PANELS at bottom
Remove footwell side trim panel on left and right. Refer to 51 43 070 REMOVING AND INSTALLING/REPLACING SIDE TRIM PANEL, FOOTWELL, ON A-PILLAR, LEFT (COOPER 4-DOOR HATCHBACK AND COOPER 2-DOOR HATCHBACK, 2020-2023) and 51 43 075 REMOVING AND INSTALLING/REPLACING SIDE TRIM PANEL, FOOTWELL, ON A-PILLAR, RIGHT (COOPER 4-DOOR HATCHBACK AND COOPER 2-DOOR HATCHBACK, 2020-2023)

Removal:

Release nuts (1) and remove holder (2).

NOTE: Different holders can be installed depending on equipment.
Graphic shows example of a F56 vehicle with holders for controller and center armrest.

Courtesy of BMW OF NORTH AMERICA, INC.

Cut into carpet in area of dotted line (1).

Ensure that cables are not damaged when doing this.

Courtesy of BMW OF NORTH AMERICA, INC.

Cut into carpet in area of dotted line (1) on left and right.

Ensure that cables are not damaged when doing this.

Take out the carpet from the vehicle and put aside.

Courtesy of BMW OF NORTH AMERICA, INC.

Installation:

Replacement only:

Lay the available carpet over the new carpet and transfer the pattern (1).

Cut out new carpet along dotted line (1).

Courtesy of BMW OF NORTH AMERICA, INC.

Place the carpet in the car.

Install holder (1) and tighten nuts (2).

Tightening torque 51 16 5AZ .

Install holder (3) and tighten nut (4).

Tightening torque 51 16 3AZ .

NOTE: Different holders can be installed depending on equipment.
Graphic shows example of a F56 vehicle with holders for controller and center armrest.

Courtesy of BMW OF NORTH AMERICA, INC.

Required reworking:

Mount end lining on front bottom of SAFETY BELT .
Mount BASS SPEAKER .
Mount FUNCTION CARRIER DASHBOARD .
Mount AIRBAG CONTROL UNIT .
Mount accelerator pedal module
Mount REAR TRIM PANELS .
Mount footwell side trim panel on left and right. Refer to 51 43 070 REMOVING AND INSTALLING/REPLACING SIDE TRIM PANEL, FOOTWELL, ON A-PILLAR, LEFT (COOPER 4-DOOR HATCHBACK AND COOPER 2-DOOR HATCHBACK, 2020-2023) and 51 43 075 REMOVING AND INSTALLING/REPLACING SIDE TRIM PANEL, FOOTWELL, ON A-PILLAR, RIGHT (COOPER 4-DOOR HATCHBACK AND COOPER 2-DOOR HATCHBACK, 2020-2023)
Mount both front seats. Refer to 52 13 001 REMOVING AND INSTALLING FRONT SEAT, DRIVER'S SIDE (COOPER 4-DOOR HATCHBACK MODELS, 2020-2023) and 52 13 002 REMOVING AND INSTALLING FRONT SEAT, PASSENGER'S SIDE (COOPER 2-DOOR HATCHBACK MODELS, 2020-2023) .
Mount REAR SEAT .