Install front bumper cover
- Position the bumper cover with the help of a support person.
- Connect all connectors depending on the equipment specification and lock in place.
- Tighten down screws (1).
TIGHTENING TORQUES SPECIFICATION
| Bumper cover to front panel | ||
|---|---|---|
| M6x20 screw | Tightening torque | 6 Nm |
NOTE:
Perform the steps on the right and left side.
- Tighten down screws (1).
TIGHTENING TORQUES SPECIFICATION
| Wheel arch cover | ||
|---|---|---|
| screw | Tightening torque | 2.6 Nm |
| Plastic nut | Tightening torque | 2.6 Nm |
- Tighten down screws (1).
TIGHTENING TORQUES SPECIFICATION
| Lower front bumper panel | ||
|---|---|---|
| screw | Tightening torque | 3 Nm |
Follow-up work