41 61 571 Removing And Installing/Replacing The Hood Hinge (Hood Removed) (Active Pedestrian Protection) Rep-Rep-RAF5641-4161071 - V.5 (Cooper 4-Door Hatchback And 2-Door Hatchback, 2020-2023)
WARNING: This page is about a different variant/trim than selected.
WARNING:
Injury hazard!
Adhere to the following SAFETY INSTRUCTIONS so as to avoid a injury hazard by the actuator.
The BATTERY GROUND LEAD must be clamped off prior to work on the hinge or engine compartment lid!
Adhere to the following SAFETY INSTRUCTIONS so as to avoid a injury hazard by the actuator.
The BATTERY GROUND LEAD must be clamped off prior to work on the hinge or engine compartment lid!
For stripping and rebuilding operations, refer to surrounding texts on KSD (FRU number 41 61 571).
Necessary preliminary work
- DISCONNECT cable from battery earth lead
- Remove ACTUATOR (active pedestrian protection)
Removal
Remove water drain channel (1).
Release screws (1) and remove hinge.
Installation
Install hinge and tighten screws (1).
Tightening torque 41 61 2AZ .
Install the water drain channel (1).
Required follow-up work:
- Install the ACTUATOR (active pedestrian protection)
- Connect BATTERY GROUND LEAD .
- ADJUST hinge together with engine compartment lid