61 62 060 Removing and installing/replacing rear wiper motor (Cooper 4-door hatchback and 2-door hatchback, 2020-2023)
Preliminary work needed:
- Remove WIPER ARM FOR REAR WIPER .
- Remove TRIM FOR TAILGATE AT BOTTOM .
Removal:
Unlock hose pipe (1) and disconnect.
Unlock and disconnect connector (2).
Loosen screws.
Pull wiper motor (3) out of grommet (4).
Installation:
NOTE:
Check grommet (4) of wiper pivot for signs of damage, replace if necessary.
Join wiper motor (3) in grommet (4).
Tighten down screws (3).
Tightening torque 61 62 2AZ .
Connect connector (2).
Connect hose pipe (1).
NOTE:
Ensure fit and detent of hose pipe (1) are correct.
Required follow-up work:
- Install TAILGATE TRIM PANEL, BOTTOM .
- Install WIPER ARM FOR REAR WIPER .
- ADJUSTING SPRAY NOZZLE .