51 11 156 Removing and installing front bumper panel: Notes

WARNING: This page is about a different variant/trim than selected.

Removal:

Release trim (1) from latch mechanisms (2) and clips (3).

NOTE: Carry out work on the right side in the same way as for the left side illustrated here.

Fig 1: Trim, Latch Mechanisms And Clips

Courtesy of BMW OF NORTH AMERICA, INC.

Release screws (1).

Fig 2: Locating Screws

Courtesy of BMW OF NORTH AMERICA, INC.

Release screws (1).

Fig 3: Locating Screws

Courtesy of BMW OF NORTH AMERICA, INC.

Release screws (1).

Pull bumper panel (2) slightly towards the front with aid of a second person.

Unlock and disconnect all plug connections depending on equipment specification.

Remove bumper panel (2) towards the front with the aid of an auxiliary person.

Fig 4: Bumper Panel And Screws

Courtesy of BMW OF NORTH AMERICA, INC.

Installation:

Position bumper panel (2) with the aid of a second person.

Connect all plug connections.

Tighten down screws (1).

Fig 5: Bumper Panel And Screws

Courtesy of BMW OF NORTH AMERICA, INC.

Tightening torque 51 11 1AZ .

Tighten down screws (1).

Fig 6: Locating Screws

Courtesy of BMW OF NORTH AMERICA, INC.

Tighten down screws (1).

Fig 7: Locating Screws

Courtesy of BMW OF NORTH AMERICA, INC.

Fasten trim (1) on latch mechanisms (2) and clips (3).

NOTE: Carry out work on the right side in the same way as for the left side illustrated here.

Fig 8: Trim, Latch Mechanisms And Clips

Courtesy of BMW OF NORTH AMERICA, INC.

Required follow-up work:

Only for Cooper JCW:

Swap over the following parts according to version: