Removing/replacing gear sensor

Preliminary work needed:

Remove front assembly UNDERBODY PROTECTION .

Removal:

Disconnect plug connection (2) of gear sensor.

Release screws (1) and remove gear sensor.

Courtesy of BMW OF NORTH AMERICA, INC.

Installation:

Install gear sensor and tighten screws (1).

Tightening torque 23 14 1AZ .

Engage plug connection (2) of gear sensor.

Courtesy of BMW OF NORTH AMERICA, INC.

Required follow-up work:

Install front UNDERBODY PROTECTION .

IMPORTANT: After installing the gear sensor, it is necessary to teach in the position of the gear sensor again.
Perform "Teach in gear sensor" service function using BMW diagnostic system using a scan tool!